Safety Information; Electrical Safety; Overload Protection; Warranty - Everbilt RSE50W-HDC Guide D'utilisation Et D'entretien

Safety Information

WARNING: The sewage basin must be vented in
accordance with local plumbing codes. These pumps are
not designed for and CANNOT be installed in locations
classified as hazardous.
CAUTION: Call an electrician when in doubt. The pump
should be connected to a separate 15 A circuit breaker or
15 A fuse block. Plugging into existing outlets may cause
low voltage at the motor. This could cause blown fuses,
tripping of motor overload or a burned out motor.

ELECTRICAL SAFETY

WARNING: Verify that the voltage and frequency of the
pump shown on the nameplate corresponds to those
available on the mains. The installer must make sure that
the electrical system is grounded in accordance with code.
WARNING: For outdoor use, the plug and connection
should be protected from water splashes. Before using the
pump, always inspect it visually (especially power cable and
plug).
WARNING: Do not use the pump if it is damaged.

Warranty

This product is guaranteed for a period of five years from the date of original retail purchase against defects in materials and workmanship.
DO NOT return this product (if it has ever been installed) to your local Home Depot store. Sewage pumps that have seen service and have
been removed carry a contamination hazard with them. If your sewage pump has failed:
□
Wear rubber gloves when handling the pump
□
Disconnect pump from power source and follow all appropriate safety precautions
Dispose of the pump according to local disposal ordinances.
Subject to the conditions and limitations described below, this product will be replaced with
specifications if the pump s cord end with cord tag and proof of purchase are returned to the retail store within the stated warranty period. '
These warranties are subject to the following conditions and limitations:
a) a proof of purchase receipt verifying the purchase location and purchase data must be provided;
b) this warranty will not apply to any product or part thereof which is worn or broken or which has become inoperative due to abuse,
misuse, accidental damage, foreign materials in the system, operating at pressures in excess of recommended maximums,
neglect or lack of proper installation, operation or maintenance (as outlined in the applicable owner's manual or operating instructions) or
which is being used for industrial, professional, commercial or rental purposes;
c) this warranty will not apply to normal wear and tear or to expendable parts or accessories that may be supplied with the product which
are expected to become inoperative or unusable after a reasonable period of use;
d) this warranty will not apply to routine maintenance and consumable items;
e) this warranty will not apply where damage is caused by repairs made or attempted by others (i.e. persons not authorized by the
manufacturer);
f) this warranty will not apply to any product that was sold to the original purchaser as a reconditioned or refurbished product (unless
otherwise specified in writing);
g) this warranty will not apply to any product or part thereof if any part from another manufacturer is installed therein or any repairs or
alterations have been made or attempted by unauthorized persons;
WARNING: If the pump is damaged, have it inspected by
an authorized service center.
WARNING: Make sure that electrical connections are
protected from flooding. Protect the plug and the power
cable from heat or sharp edges.
WARNING: The power cable must be replaced by
qualified personnel only. Grounding: The plug of the power
cable has a double grounding contact, so that grounding
can be achieved by simply inserting the plug.

OVERLOAD PROTECTION

This pump series has a built in thermal protection switch, it will
protect motor from burning out due to overheating/overloading.
When motor cools down, overload protector will automatically
reset and start motor.
If overload trips frequently, check for cause. It could be a stuck
impeller, wrong/low voltage, or electrical failure in motor. If an
electrical failure in the motor is suspected, have it serviced by
a competent repairman.
the same model or one of equal value or
3
Please contact 1-844-883-1872 for further assistance.
HOMEDEPOT.COM