Table Des Matières; Safety Information; Precautions - Everbilt RSE50W-HDC Guide D'utilisation Et D'entretien

Table of Contents
Table of Contents .......................................................... 2
Safety Information ......................................................... 2
Precautions ..............................................................................2
Safety Information ......................................................... 3
Electrical Safety .......................................................................3
Overload Protection .................................................................3
Warranty ......................................................................... 3
Additional Limitations ..............................................................4
Notice to Consumer .................................................................4

Safety Information

PRECAUTIONS

1. Keep this instruction manual in a safe place for future
reference.
2. Do not cut off the ground pin or use an adapter fitting.
3. Do not use an extension cord.
4. The pump power cord should be connected to a separately
fused, grounded line with a minimum capacity of 15 A. It can
be connected to a non-fuse breaker at the recommended
amperes.
5. Installation and electrical wiring must adhere to provincial
and local codes and must be completed before priming the
pump. Check appropriate community agencies, or contact
local electrical and pump professionals.
6. The voltage of the power supply must match the voltage of
the pump.
7. Place pump on dedicated circuits to avoid low voltage.
8. Plastic PVC pipe can be installed in the outlet piping. A drain
hose, galvanized steel or copper pipe may be used if
desired. All piping must be clean and free of all foreign
matter to prevent clogging.
. The pump will be inadequate if suspension liquids contain
solid particles larger than 2 in. (5.1 cm).
LIMITATIONS
This pump was designed exclusively for SEWAGE WATER
TRANSFER applications, i.e. transferring water with 2 in.
suspended, stringy solids in it, and NOT to pump clear water
from sump pits, hot water applications, water fountain/features
applications, etc.
Pre-Installation .............................................................. 4
Installation Requirements ........................................................4
Performance Chart ...................................................................5
Materials Required (Not Included) ...........................................5
Installation ..................................................................... 6
Operation ....................................................................... 7
Care and Cleaning ........................................................ 7
Troubleshooting ............................................................ 8
DANGER: Keep pump equipment out of the reach of
children! Failure to follow the directions given could cause
serious risk to individuals or objects.
WARNING: Warnings indicate to the operator that the
failure to follow an instruction may damage the pump
and/or the system.
WARNING: Do not work on the pump until power is
unplugged.
WARNING: Before installing or servicing this pump, be
certain the power source is disconnected.
WARNING: These pumps come with a grounding
conductor and a grounding type attachment plug. Do not
connect the pump to a power supply until permanently
grounded. For maximum safety, connect the pump to a
circuit equipped with a fault interrupter device when
positioning the pump's grounding wire.
WARNING: The sewage basin must be vented in
accordance with local plumbing codes. These pumps are
not designed for and CANNOT be installed in locations
classified as hazardous.
WARNING: The following may cause severe damage to
the pump and will void the warranty:
(a) Using an extension cord
(b) Cutting off the ground pin or using an adapter fitting
(c) Working on pump or switch while plugged in
(d) Removing motor housing, unscrewing impeller, or
otherwise removing impeller seal
(e) Running the pump continuously
(f) Pumping chemicals or corrosive liquids
(g) Pumping gasoline or other flammable liquids
2