Troubleshooting - Klarstein CHILLOUT Mode D'emploi

EN
20

TROUBLESHOOTING

1. Please note, if a power failure occurs due to disconnection of the power cord, or
the power button has been pushed off during an ice making cycle, small ice chips
may formed and lodge in the automatic shovel causing it to jam. If this occurs, the
ice chips may be removed by disconnecting the power cord and gently pushing the
shovel to the rear of the cabinet and removing the ice chips, then restarting.
2. Please check if the water reservoir is flat when the ice shovel can not remove the
ice to the ice basket. If not, please push the ice shovel gently with finger, then press
POWER button to restart.
Problem Possible Cause
The appliance is The voltage is too low.
exceptionally loud
and humming.
The "ADD WATER" There is too little water in
indicator light the tank.
comes on.
The pump is full of air.
Indicator lights on The fuse is broken or the
display are not on. appliance is switched off.
The ice cubes are There is ice from the last
too large and stick run in the water tray.
together.
The appliance is Problem with the
running but does refrigerant.
not produce ice.
The compressor is broken.
The fan motor is damaged.
All lights flash Water tray is blocked by
simultaneously. ice cubes.
The machine has The solenoid is broken.
been working, but
the water has been
warming.
Suggested Solutions
Stop the appliance and plug
it into an outlet that has the
specified voltage.
Add some water until it reaches
MAX position.
Press the POWER button to restart
the appliance.
Replace the fuse or switch on the
appliance.
Switch to standby mode and
remove the ice.
Contact a specialist company for
inspection and repair.
Remove the plug from the socket
to take out the ice which is
blocking the tray. Then insert the
plug back into the socket and
press the POWER button, the
machine will restart 3 minutes
later.
Have the solenoid replaced.
Contact a specialist company.