Cleaning And Care; Troubleshooting - Klarstein 10029294 Mode D'emploi

Masquer les pouces Voir aussi pour 10029294:

Mode d'emploi (56 pages)

Table Des Matières

Table des Matières

Les langues disponibles

4. Press "START" button to turn unit on. The ice maker begins to work. Note: For the first three cycles,the ice

may be small and irregular in size,and it would last for longer time,maybe even around 60 minutes.

5. If indicator ‚ICEFULL' is in red with noise ‚DI DI' , please take out the ice with the scoop.

6. Press ‚STOP' button to stop the machine.

7. Remove the drain plug to drain remaining water from the water reservoir. Screw the drain plug back in place

after the water has been drained.

• Clean the inner liner, water box, ice shovel and evaporator frequently. When cleaning, unplug the unit and

remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside and the outside surface

of the Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids, gasoline or oil. Rinse

thoroughly before starting.

• Keep ventilation openings in the appliance enclosure, or in the built-in structure, clear of obstruction. Do not

use mechanical devices or other means to accelerate the defrosting process, other than those recommen-

ded by the manufacturer.

• If the machine is reused after a long time , maybe the water pump cannot pump sufficient water due to the

air inside, the ADD WATER water indicator light will turn on in this case . To correct this press the START

button again, then the machine will work normally.

• To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24 hours.

• If the compressor stops for any reason such as water shortage, too much Ice, power off, etc... Do not start the

system right away, wait 3 minutes, and then re-start the Ice maker.

• Always change with fresh water before starting ice production at initial installation or after long shut-off

periods.

• Auto clean function,if the unit is not used for a long time,before the use,you can plug the unit first,and

then press the button "ON/OFF" button for 5seconds,the unit will clean itself(all indicators illuminate every

5seconds,pump take water for 5times,each time 30seconds)

Please note, if the water filled to the evaporator is not symmetrical, small sundries maybe be formed and lod-

ged in the pipe which will mean that water will be filled to the evaporator causing it to jam. Please pull out the

cap of the pipe, then let the water through the pipe in order to clean the pipe, then you can replace the cap. It

will make formal ice cubes.

Problem

The compressor works abnormally

with a buzzing noise.

The light of ADD WATER is on.

All manuals and user guides at all-guides.com