Care And Cleaning - Klarstein KRISTALL Mode D'emploi

CARE AND CLEANING

• Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator
frequently. When cleaning, unplug the unit and remove the ice cubes. Use a diluted
solution of water and vinegar to clean the inside and the outside surface of the
Ice maker. Do not spray Ice maker with chemicals or diluted agents such as acids,
gasoline or oil. Rinse thoroughly before starting.
• Keep ventilation openings in the appliance enclosure, or in the built-in structure,
clear of obstruction. Do not use mechanical devices or other means to accelerate
the defrosting process, other than those recommended by the manufacturer.
• To ensure the cleanness of ice, please change water for water reservoir at least once
one day. If do not use for a long time, please drain the water out and clean it up.
• If the compressor takes a strike action for shortage water, fully water or interruption
of power supply, it will delay for 3mins to start up after restarted.
• Always use fresh water before starting ice production either at initial installation or
after a long shut-off period.
TROUBLESHOOTING
Problem Possible Cause
The compressor The voltage is lower than
works abnormally recommended.
with a Buzzing
Noise.
Indicator light of Water of Water box is not
lack of water on much enough.
The floater is not installed
right.
Der Schwimmer-Schalter
ist kaputt.
Indicator lights on Blown fuse/ No power.
display are not on.
Suggested Solution
Stop the Ice maker and do not
restart until the voltage is normal.
Add enough water toWater box.
Call the service centre.
Replace fuse / Turn power on.
EN
17