Samsung NY63875S Série Mode D'emploi page 59

Problem
The oven racks are This is normal.
difficult to slide.
Fan noise. This is normal.
The convection fan This is normal.
is not working.
Others
Problem
The product is not The appliance has been
level. installed improperly.
The leveling leg(s) is (are)
damaged or uneven.
The kitchen cabinets are
not properly aligned and
make the range appear to
be not level.
NY63T8751SS_AA_DG68-01218A-00_EN+MES+CFR.indb 59
Cause Action
Apply a small amount of
vegetable oil to a paper towel,
and then wipe the edges of
the oven racks with the paper
towel. Racks become dull and
hard to slide if they are left in
the oven during a self-clean
cycle.
The convection fan runs until
the function is over or the
door is opened.
The fan starts automatically
when the oven reaches the
preheat temperature.
Cause Action
Make sure the floor is level,
strong, and stable. If the floor
sags or slopes, contact a
carpenter.
Check and level the range. (See
the Installation Instructions.)
Ensure that cabinets are
square and provide sufficient
room for installation.
Problem Cause
The display goes The electrical outlet
blank. Ground Fault Interrupter
(GFI or GFCI) has been
tripped and needs to be
reset.
Your digital control has
been damaged.
Food does not The wrong cooking mode
bake or roast is selected.
properly in the
The oven racks have not
oven.
been positioned properly
for the foods being
cooked.
Incorrect cookware or
cookware of improper
size is being used.
The oven thermostat
needs adjustment.
There is aluminum foil on
racks or oven bottom.
The clock or timers are
not set correctly.
Action
Replace fuse or reset circuit
breaker.
See page 23.
See page 27.
See page 17.
See page 42.
Remove foil.
See page 16.
English 59
2020-03-23 6:46:20