Selecting Temperature; Automatic Switch-Off Function; Fast Heating; Cleaning And Care - Sanitas SHK 55 Easyfix Mode D'emploi

3.2 Selecting temperature

The fastest way to heat up the heating pad is to fi rst set the switch to the highest setting. A lower
setting can be selected later if required.
After switching on the heating pad, the setting starts fl ashing briefl y, while the heating pad conducts
a self-test. Then the setting remains illuminated continuously.
3.3 Temperature settings
Setting: 0 Off
1 Minimum heat
2 Medium heat
3 Maximum heat

3.4 Automatic switch-off function

These heating pads have an automatic switchoff function which stops the heat supply
approx. 90 minutes after switching on the pad. The illuminated function display then
starts to fl ash. To operate the heating pad again, you must fi rst set the switch to zero.
After about 5 seconds, it can be switched on again.
If the heating pad is no longer used after the timed switch-off , it should be switched off
(setting "0") or else unplugged from the mains.

3.5 Fast heating

These heating pads have a fast heating function which allows them to heat up quickly within the fi rst
10 minutes.

4. Cleaning and Care

Before cleaning the pad, always unplug it from the mains. Smaller stains
can be removed using a cloth or moist sponge together with a little liquid
detergent for delicate fabrics if necessary. Do not use any cleaning agents
containing solvents on the appliance.
Please note that the heating pad should not be dry-cleaned, wrung out,
machine-dried, pressed or ironed.
Before washing, fi rst remove the plug-in connection together with the switch from the heating pad.
Set the washing machine to a gentle washing cycle at 40 °C.
For ecological reasons, we recommend that the heating pad is only washed together with other tex-
tiles. Use a washing powder or liquid for delicate fabrics and dose it according to the manufacturers
instructions. Please note that excessive washing will wear out the heating pad. For this reason, the
heating pad should only be machine-washed a maximum of 10 times throughout its entire life.
When drying the heating pad, do not use clothes pegs or anything similar, and never switch the
heating pad on to dry it!
Do not reconnect the switch to the heating pad until the plug-in connection and the heating
pad are completely dry.
5. Storage
If you are not going to use the heating pad for some time, we recommend storing it in its original
packaging in a dry place without weighing it down.
Allow the heating pad to cool down beforehand.
8
90
min
STOP