Remote Controller - AVer CAM520 Pro Mode D'emploi

Overview
1
1 Status LED
2 IR sensor
3 DIP switch
 1: Only support for advanced model. DIP Switch is for HDMI output resolution settings. Check
user's manual (page 2) for more details.
 2: Advanced model supports PoE+.

Remote Controller

Camera Select
Camera Directional
Control
OSD Menu
SmartFrame
Zoom In/Out
Preset
Brightness -
Call/Answer*
*Function requires AVer PTZApp
**Not support for CAM520 Pro
 Press and hold the number button "
turn on or off the WDR function.
 AAA Batteries (required)
2
4
5
1
6
Enter**
3 4 5 6 7 8
1
HDMI port
USB3.1 Type B port
RS232 in/out port
 Camera select: If you only have one
camera and don't need to do any setting,
the default is camera 1. If you press
camera 2 or 3 on the remote control, you
will find your remote can't control your
camera. In this case, please press
camera 1 on your remoter again.
 OSD Menu: Only available for advanced
model.
 SmartFrame: Press for 1 second can
switch the SmartFrame function
between auto and manual. A message
(as figure shown) will display on the
screen to indicate in auto or manual
mode.
[Note] While in conferencing meeting,
participants must face the camera for
" can face detection. Side face is not
detectable. Refer to page9 or user's
manual (p.14) for more details.
English-2
9
7 DC 12V power plug
2
8 Ethernet port
9 Kensington Lock