Plusmed pM-2012 Mode D'emploi page 14

INSTALLATION
Unpack the box to check for any damage which may have occurred during
shipment. If there are damages, please contact your dealer immediately.
Pump & Mattress Installation
NOTE
1. Make sure the pump unit is suitable for the local power voltage.
2. The plug is also served to disconnect the device.
CAUTION - The pump can only be applied to the mattress recommended
by the manufacturer. Do not use it for any other purpose.
5.Then turn the main power switch to ON position which located on the right
side of the pump.
Several installation tips are listed below:
After installation, the extra length of the power cord, if any, should be neatly
arranged to avoid any tripping accidents. The EQUIPMENT should be firmly
placed at position where users/doctors can access easily.
1. Hang the pump onto bed rail (foot-end), and adjust
hangers to best upright position of the pump, or
place the pump on a flat surface.
2. Place the mattress on the existing mattress or the
bed. Tuck the extension sheet under the existing
mattress if necessary.
NOTE - Please cover the mattress with a cotton
sheet to avoid direct skin contact and for patient's
comfort.
3. Connect air hose connectors from air mattress to the
pump unit.
NOTE - Check and ensure the air hoses are not
kinked or tucked under mattress Please cover the
mattress with a sheet of clothing to avoid direct skin
contact.
4. Plug the power cord into electrical outlet.