Tools Required For Assembly - Agri-Fab 45-02402 Notice D'utilisation

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Screwdriver
(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrench
(2) 9/16" Wrenches
1. Remove the hardware pack and all loose parts
from the carton. Be sure the carton is empty before
discarding.
2. Lay out all the parts as shown in the carton contents.
DO NOT LEAVE THE CART UNATTENDED IN
UPRIGHT POSITION DURING ASSEMBLY. A
FALLING CART CAN CAUSE PERSONAL INJURY!
PAY CLOSE ATTENTION TO THE STABILITY OF
THE CART WHILE IT REMAINS IN AN UPRIGHT
POSITION. FOR BEST STABILITY, ASSEMBLE
ON A SMOOTH, LEVEL SURFACE.
3. Position cart body halves upright on a smooth level
surface such as a garage floor or a paved driveway.
See figure 2.
4. Assemble halves together using three 1/4" x 3/4" hex
bolts and 1/4" nylock nuts as shown in figure 2. Do not
tighten yet.
1/4" x 3/4" HEX BOLT
FIGURE 2
CAUTION
1/4" NYLOCK NUT
ENGLISH
5. Position the tailgate reinforcement bracket on outside of
cart as shown in figure 3. Assemble to the bottom of the
cart body using four 5/16" x 3/4" truss head bolts and
5/16" nylock nuts. Do not tighten yet. See figure 3.
6. Position the tailgate guides on the inside of the cart bodies
with guide channels to the front as shown in figure 3.
Assemble using four 1/4" x 3/4" hex bolts and 1/4" nylock
nuts. Do not tighten yet. See figure 3.
5/16" NYLOCK NUT
FIGURE 3
7. At this time, with the cart body halves pulled together,
tighten the four truss head bolts assembled in step 5
and then the four hex bolts assembled in step 6. Leave
loose for now the bolts that were assembled in step 4.
8. Carefully reverse the position of the cart so that it rests
on the end with the just assembled tailgate reinforcement
bracket, as shown in figure 4. Proceed with the assembly
steps which follow.
FIGURE 4
4
1/4" NYLOCK NUT
TAILGATE GUIDE
1/4" x 3/4"
HEX BOLT
5/16" x 3/4"
TRUSS HEAD BOLT
TAILGATE
REINFORCEMENT
BRACKET