Check Operation - Electrolux EW30GS65G Instructions D'installation

30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
9.
Leveling the Range
Models Equipped with Leveling Device
Level the range after installation in the cutout
opening.
1. Open the range drawer. The leveling screws
control the height of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop surface is sitting level
on the countertop (Figure 8).
a.To adjust the front legs, use a wrench on
the leg base and turn clockwise to lower or
counterclockwise to raise.
b.To adjust the rear legs, use a ratchet or a
nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to
raise.
3. Check if the range is level by installing an oven
rack in the center of the oven and placing a
level on the rack (Figure 9).
4. Take 2 readings with the level placed
diagonally in one direction and then the other.
Level the range, if necessary, by adjusting the
leveling legs.
5. If the range cannot be level, contact a
carpenter to correct sagging or sloping floor.
Use this Screw
to Adjust Rear Leveling
Device Height
RAISE
Leveling
Screw
LOWER
Font
Leveling
Leg
LOWER
RAISE
(Models with Sealed Top Burners)
Rear Leveling
Device
LOWER
RAISE
Figure 8
Figure 9
8
10.

Check Operation

Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Do not touch the elements or burners. They may be hot
enough to cause burns.
Remove all packaging from the oven before testing.
1. Install Burner Caps and Triple burner head
This cooktop is equipped with sealed burners.
A. Unpack the burner grates.
B. Regular Burners: Burner heads and burner
caps are already on the surface. Remove all
tapes from burner caps and verify if they are
correctly place on the burner heads (see Figure
Burner Cap
Gas Opening
Electrode
10).
C. Triple Burner (if equipped): Remove all tapes
from burner cap. Remove the burner cap and
head. Remove and discard the packaging
material. Replace head and cap on the triple
burner. Be careful not to damage the
electrode while placing the head over the
orifice. Make sure electrode fits correctly into
slot in burner head (see Figure 11).
D. Be sure that all the burner caps and the triple
burner head are correctly placed BEFORE using
your cooktop.
NOTE: There are no burner adjustments necessary on
this cooktop.
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
Burner Head
Figure 10