Belkin OmniView MATRIX Mode D'emploi page 12

F1D208-OSD_EU_man.qxd 4/20/00
Hardware Installation
• RESET the MASTER unit by pressing the BANK and any port button simultaneously. This is necessary for the
MASTER unit to detect the newly added slave unit.
• Verify that the MASTER unit has detected the new slave by pressing the BANK button. If it detected the
new slave properly, the LED display on the MASTER will register the slave unit's bank address. If you have
many slave units, you may have to press the BANK button many times to cycle through all of the preexisting
slave units before reaching the newly added unit.
• Now you can power up the computers connected to the newly added slave unit. After all the computers
have booted up, you may need to RESET the MASTER unit again to detect the presence of powered
computers on the new slave unit.
NOTE: The OmniView ™
daisy-chain compatible with any other KVM switch.
4:37 PM Page 10
MATRIX 2x8 can only be daisy-chained to other OmniView
10
(continued)
™ MATRIX 2x8 units. They are not