Installation - Other Fixtures - ETI Solid State Lighting 54296146 Guide D'utilisation Et D'entretien

Installation - Strip Lights (continued)
11
Installing LED Tubes
□ Install LED tubes (A) with
the end labeled "power
this end" to the wired
sockets.
□ Turn the tube a quarter
turn to lock it in place.

Installation - Other Fixtures

NOTE: LED linear tubes require single end power only. Wiring to one side of the fixture is sufficient. Ensure the lamp end labeled "POWER
THIS END" is installed to the live circuit.
CAUTION: Sockets or lampholders must be non-shunted. Power flows through the LED tube.
1
Turning off the Power
□ Shut off power at the electrical panel
before beginning the installation.
2
Removing Existing Tubes
□ Depending upon the
fixture type, remove the
fixture lens, and set
aside.
□ Remove existing
fluorescent tubes and
set aside to recycle in
accordance with local
requirements.
A
C
12
□ Restore power at the electrical panel.
□ Turn on the light switch to activate the
fixture.
AA
3
Removing the Ballast Cover
□ If needed, remove and set aside the ballast cover.
4
Disconnecting Wires
□ Disconnect the hot and neutral (black and white) wires
from the fluorescent ballast. The ballast is not required to
operate these 4ft. LED tubes (A).
□ Optional: Cut the wires on both ends of the ballast and
remove the ballast and starter. Dispose of the ballast and
recycle in accordance with local requirements.
8
Restoring Power