AL-KO HT 600 FLEXIBLE CUT Mode D'emploi page 15

HT 600, HT 700
Work area safety
Keep work area clean and well lit.
Cluttered or dark areas invite accidents.
Do not operate power tools in explosive
atmospheres, such as in the presence of
fl ammable liquids, gases or dust.
Power tools create sparks which may ignite
the dust or fumes.
Keep children and bystanders away while
operating a power tool.
Distractions can cause you to loose control.
Electrical safety
Power tool plugs must match the outlet.
Never modify the plug in any way. Do
not use any adapter plugs with earthed
(grounded) power tools.
Unmodifi ed plugs and matching outlets will
reduce risk of electric shock.
Avoid body contact with earthed or ground-
ed surfaces, such as pipes, radiators, ran-
ges and refrigerators.
There is an increased risk of electric shock
if your body is earthed or grounded.
Do not expose power tools to rain or wet
conditions.
Water entering a power tool will increase
the risk of electric shock.
Do not abuse the cord. Never use the cord
for carrying, pulling or unplugging the po-
wer tool. Keep cord away from heat, oil,
sharp edges and moving parts.
Damaged or entangled cords increase the
risk of electric shock.
470519_b
When operating a power tool outdoors,
use an extension cord suitable for outdoor
use.
Use of a cord suitable for outdoor use redu-
ces the risk of electric shock.
If operating a power tool in a damp locati-
on is unavoidable, use a residual current
device (RCD) protected supply.
Use of an RCD reduces the risk of electric
shock
Personal safety
Stay alert, wat ch what you are doing and
use common sense when operating a pow-
er tool. Do not use a power tool while you
are tired or under the infl uence of drugs,
alcohol or medication.
A moment of inattention while operating
power tools may result in serious personal
injury.
Use personal protective equipment. Al-
ways wear eye protection.
Protective equipment such as dust mask,
non-skid safety shoes, hard hat, or hearing
protection used for appropriate conditions
will reduce personal injuries.
Prevent unintentional starting. Ensure the
switch is in the off-position before connec-
ting to power source, picking up or carry-
ing the tool.
Carrying power tools with your fi nger on the
switch or energising power tools that have
the switch on invites accidents.
GB
15