Mounting Of High Pressure Hose; Operating Your Pressure Washer; Mounting Of Spray Lance; Water Connection - Berner BHPC 150-1 4-in-1 Lance Instructions D'emploi

BHPC 150-1 4-in-1 Lance
DE
4.4 Mounting of high pres-
sure hose
EN
FR
IT
ES
NL
DA

5 Operating your pressure washer

NO
SV

5.1 Mounting of spray lance

FI
PT

5.2 Water connection

34
A
B
NOTE!
Always remove any dirt from
the nipple before connecting the
spray lance to the spray handle.
An ordinary 1/2" garden hose of
min. 10 m and max. 25 m will
be suitable.
NOTE: Connec-
tion to the public
mains according
to regulations.
Unwind the high pressure hose
completely.
Attach the high pressure hose
(3) to the spray handle (6).
1. Pull the blue quick-release
grip (A) of the spray gun
backwards.
2. Insert the nipple of the spray
lance (B) into the quick-re-
lease connection and release
it.
3. Pull the spray lance (or other
accessory) forwards to check
that it is securely attached to
the spray gun.
IMPORTANT! Only use wa-
ter without any impurities. If
there is a risk of silt, sand or
sediment in the inlet water (i.e.
from your own well), an addi-
tional fi lter should be mounted.
1. Let the water run through the
water hose before connecting
it to the machine to prevent
sand and dirt from penetrat-
ing the machine.
Note: Check that the fi lter is
fi tted in the water inlet pipe
and that it is clean and free
from debris.
2. Connect the water hose to
the water supply by means
of the quick connector (inlet
water, max. pressure: 10 bar,
max. temperature: 60°C).
3. Turn on the water.
Original Instructions