Sharp SJ-T2435H4I-EU Guide D'utilisation page 14

CHAPTER -3: USING YOUR FRIDGE FREEZER
Adapti-Lift door shelf (In some models)
Fig.1
Note: Before moving door shelf is loaded, you must hold the shelf by supporting the bottom. Otherwise, door shelf
could fall off the rails due to the weight. So damage may occur on the door shelf or rails.
Visual and text descriptions on the accessories section may vary according to the model.
Cleaning
• Make sure to unplug the fridge before cleaning.
• Do not wash your fridge by pouring water .
• You can wipe the inner and outer sides with a soft cloth or a sponge using warm and soapy water.
• Remove the parts individually and clean with soapy water. Do not wash in washing machine.
• Never use flammable, explosive or corrosive material like thinner, gas, acid for cleaning.
• You should clean the condenser with broom at least once a year in order to provide energy saving and increase
the productivity.
Make sure that your fridge is unplugged while cleaning.
Replacing The LED (if an LED is used as lighting)
1 LED strip in freezer compartment and 2 LED strips in cooler compartment are used to
illuminate your appliance.
Please contact the Sharp help desk as this should be changed by authorized personnel
only.
Note: Numbers and location of LED strips may change according to different models.
Six different height adjustments can be made to provide storage
areas that you need by Adapti-Lift.
To change the position of Adapti-Lift ;
Hold the bottom of the shelf and pull the buttons on the side of
the door shelf direction of arrow (Fig.1)
Position door shelf the height you need by moving up and down.
After you get the position that you want the door shelf, release
the buttons on the side of the door shelf (Fig.2) Before releasing
the door shelf, move up down and make sure the door shelf is
fixed
EN -12-
Freezer compartment
LED strip lamp
Refrigerator compartment
LED strip lamp
Fig.2