Connecting To The Gas Supply; Almost Ready To Grill; Connecting The Flexible Hose To Gas Supply - Weber Spirit E-210 GBS Guide Du Propriétaire

ALMOST READY TO GRILL

A quick-disconnect device
connects your grill to the gas
supply. After you have made
the connection, a leak check
will need to be performed.

CONNECTING TO THE GAS SUPPLY

CONNECTING THE FLEXIBLE HOSE TO GAS
SUPPLY
A) Starting from inside the cabinet, route the flexible gas
hose out of the opening in the rear panel (1).
B) Slide the collar of the quick-disconnect back (2).
C) Push male fitting of the hose into the quick-
disconnect and maintain pressure. Slide the collar
closed (3). If it does not engage or lock, repeat
procedure.
This procedure will produce a gas joint. Gas will not flow
unless the quick-disconnect is properly engaged. To
disconnect the hose, push collar back and pull out the
plug. (This automatically shuts off gas.)
Your Weber grill comes equipped with a model specific
®
hose that was attached during the manufacturing process.
This specific hose must be used for proper performance.
If the hose becomes worn or damaged, contact the
Customer Service Representative in your area using the
contact information on our website.
Note: Do not turn on gas source until you have performed a
leak check. Refer to "CHECKING FOR GAS LEAKS."
1
1
Shutoff valve
2 Pipe nipple
3 Socket
NATURAL GAS HOSE CONNECTION
2 3 4
4
Dust covers
5 Male connection
6 Swivel connection
1
2
3
5
WWW.WEBER.COM
6
9
®