Series Dct1000 Dust Collector Timer Controller (Cont'd); Dimensional Specifications; Installing The Dct1000 - ISTblast AW16000 Manuel D'instructions

SERIES DCT1000 DUST COllECTOR TImER CONTROllER (CONT'D)

Warning : Always install and service this device with thepower off and a lockout installed if required.
Line voltages will be exposed at the power/output connector and at the fuse. For this reason, we
have installed a plastic guard to protect the user from accidentally contacting line voltages.
Please note that the power guard serves as a safety feature and should not be removed under any circumstances.
For ease of installation and maintenance, the connectors and fuse have been left unprotected. The open frame
design of the DCT1000 will require an enclosure that meets appropriate safety and local code requirements.
For optimal performance, the enclosure should also protect the controller from dirt, water and direct sunlight.
There are no special orientation requirements, and the controller mounts easily using the mounting holes on
the factory installed base plate.
Caution: Do not run control wires, communication cables,
or other class 2 wiring in the same conduit as power
leads. The system may malfunction if class 2 wiring is run
together with power conductors.

Dimensional Specifications

1.0 — INSTAllING THE DCT1000
AW16000 - Manuel d'instructions
L
a référence en treaitement de surface
25