Gardner Bender 910B Manuel De L'utilisateur page 5

INTRODUCTION
This manual is intended to help the operator
of this product become familiar with the safe
use, maintenance and care of this product.
This manual should be kept with this product
at all times.
Please inspect product before every use.
CAUTION
Inspect the tool for excessive wear or damage.
A damaged tool could fail resulting in injury
or damage.
DANGER
This product is designed for manufactures
intended use. Any other use than which it is
intended can cause serious injury.
Gardner Bender recommends this hand bender
to be used with Gardner Bender handles.
BENDING CONDUIT
Typical bends
*Bending conduit on floor
1. Mark your conduit.
2. Insert conduit through
hook at front of bender until your mark lines
up with arrow. Please see Figure 1.
3. Place one foot on the
pedal of the bender and
apply pressure while
pulling back on the handle
(Maintain pressure on
conduit through bend).
Please see Figure 2.
Insert conduit
until mark aligns
with arrow
Figure 1
Figure 2
2