ubbink Ubiflux W180 Consignes D'installation page 110

Chapter 9
7 Wash the exchanger with hot water (max. 55°C ) and a
regular detergent. Then rinse the exchanger with clean hot
water.
8 Slide the fan assembly out of the appliance.
9 Both fans are now accessible and can be taken out.
10 Clean the fans with a soft brush.
Make sure the balancing weights do not shift!
26
12 Place the fans back.
13 Place the complete fan assembly back into the appliance.
14 Connect the fan cables to the board again.
Refer to the sticker in the appliance for the correct position
of the connectors.
15 Slide the mounting plate with the control board into the ap-
pliance and mount the display. Reconnect all disconnected
cables back into their original positions.
16 Place the heat exchanger back into the appliance.
17 Place the front cover.
18 Place the filters back into the appliance with the clean side
facing the exchanger.
19 Close the filter door.
20 Switch on the power supply.
21 Switch on the appliance on the control panel (press "-" key
for 5 seconds ).
22 After cleaning the filter or placing a new filter, reset the filter
indication by pressing the "R" key for 5 seconds.
Ubiflux W180 / W180+
Maintenance