Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Exhaust Hood
Your range is equipped with a variable speed range hood that may be either vented directly to the outside, or
may be installed ventless. An exhaust filter is included with your hood. The filters should be cleaned periodically
in soapy water. Extras are available from your dealer or directly from Heartland. Please order 4 or more filters
at one time to save freight and handling charges.
Ventless Installation
Your unit is already set up for ventless operation. Cooking fumes are drawn through the filters and exhausted
through the rear of the hood, back into the room. Install the exhaust filter in their location under the closet by
first removing the light lens. Then on one side, insert the filter into the groove and slide into place.
Installation of Ducting
Installation through an outside wall
Remove air deflector (used for ventless operation only). Cut a 3 1/2 x 10 1/2 ( 88.9mm x 266.7 mm) hole through
the wall directly behind the range hood outlet (See Figure 4.), making sure no wall studs are cut. Push range into
position. From outside of the house, measure distance from the siding to the range outlet. Cut duct pipe that length,
plus 1" (25.4mm) for overlap into outlet. Attach vent hood to pipe. Caulk the back of vent hood and around pipe
where it goes through wall and into range hood outlet so caulking seals against outside siding.
Complete installation by following directions under Ventless Installation.
Installation through an attic to an outside wall
If the vent elbows are embedded in the wall, the range may be positioned as shown in Figure 4. Continue the duct
through the ceiling into the attic. Terminate duct either on an outside wall just below the soffit using a vent hood
or through the roof with a roof cap. Seal with caulking around and under cap or hood.
Complete your installation by following directions under Ventless Installation.
11
Figure 4
Exhaust venting
options
Publicité
Chapitres
Table des Matières
