Siemens 7XV5654-0BA00 Manuel page 56

English
9 pole Sub-D socket X1 with two 24 V electrical outputs
Pin
1
2
3
4
5
6
7
8 + 24 V DC (output 2)
9
Tab. 2: Pin assignment of X1 (9 Pin Sub-D socket)
Screw terminals X5
Connection
X5
X5
Tab. 3: Terminal X5
Jumper position for the pickup voltage of binary input BI2
Jumper
X100
X100
Tab. 4: Pickup voltage o binary input BI2
To change the jumper position the following work has to be done:
• Remove the power supply from the device
• Remove the cover from the housing
• For that, press the snap noses of the cover carefully with a small screw-driver
into the housing.
• Locate the jumper according Tab. 4
• Snap on the cover onto the housing
56 / 69
Meaning
+ 24 V DC output 1)
not assigned
- 24 V DC (output 1)
- 24 V DC (output 2)
not assigned
not assigned
not assigned
not assigned
Meaning
Binary input BI2 (L+)
Binary input BI2 (L-)
Position
1 – 2
2 - 3
Symbol
Sync. 1
GND (switched on)
GND (switched on)
Sync. 2
Pickup voltage
fat = factory setting
7XV5654-0BA00
Direction as DTE
Output
Output
Output
Output
Symbol
1
2
17 V
70 V
C53000-B1175-C168-1