Hahnel Giga T Pro II Manuel D'instructions page 6

To set parameters for Basic
Programme
14 Long:
A: For Single Shot Set to
00 00 00 values
B: For Continuous
Shooting
Sets the length of the
contiuous shooting burst.
C: Bulb Exposure - Sets
the length of time the
shutter is open
15 Interval 1:
Time interval between
shooting or, if in continuous
shooting mode, between
bursts of shooting.
Must be set higher than camera shutter
speed
16 N1:
A: For Single Shot Sets
the Number of shot taken
B: For Continuous
Shooting
Number of bursts of
Continuous Shooting.
C: Bulb Exposure -
Number of shots taken
To set parameters for Repeating of
Programme
17 Interval2:
Time interval between
each repeat of "Basic
Programme"
18 N2:
Number of times the above
"Basic Programme" is
repeated.
The programme is now set. Press
(play/stop) to activate or stop the
programme.
Note:
Double green flash on receiver
indicates an interval timer programme is
in operation.
To Run Basic Programme one time
only
Set parameters for Basic Programme as
normal. Ignore Interval 2 setting and set
N2 = 1
See www.hahnel.ie for examples
FAQ's
To turn off the autofocus in between shots
of sequential shooting or the Basic Timer
Function, ensure Autofocus is disabled on
your camera.
A number of channels are available on
your remote control to allow you to use
several receivers, each set to a different
channel, activated by one single
transmitter. Simply change the channel on
the transmitter as desired to activate each
seperate receiver.
To calculate the number of shots taken,
multiply N1 x N2.
If using bursts of continuous shooting, to
calculate the number of shots taken,
multiply 'frames per second' setting of the
camera x Long x N1 x N2.
Caution
• Do not modify product
• Keep receiver and transmitter dry at
all times
• Do not use in the presence of
flamable gas
• Keep out of the reach of children
• Do not expose to excessive
temperatures or strong direct sunlight
• Do not leave the unit in the trunk or
on the dashboard of a vehicle.
Overheating can result in leaking, fire
or explosion
• Observe correct polarity
• Dispose in accordance with
appropriate environmental regulations
• Take battery out of unit if stored for
an extended period of time.
R&TTE Directive Declaration
Hähnel Industries hereby declares that the
Giga T Pro II is in compliance with the
essential requirements and other relevant
provisions of the R&TTE Directive
1999/5/EC. A copy of the Declaration of
Conformity can be viewed at
www.hahnle.ie