Hahnel Giga T Pro II Manuel D'instructions page 4

Receiver
LCD Screen
1
Power ON/OFF Button
2
& Channel Selector
Backlight Button ON/OFF
3
& Channel Selector
LED light
4
Default Receiver LCD Screen
Transmitter
LED light
5
Transmitter Button
6
LCD Screen
7
Play / Stop Button
8
Power ON/OFF Button
9
& Backlight Button ON/OFF
Centre Button to confirm settings
10
4-Way Joypad
11
Default Transmitter LCD Screen
Cable
Cable Connector
12
A
Setting up Giga T Pro II
Switching on your Giga T Pro II
Wireless Remote Control
Ensure the camera and remote control
receiver are turned off before connecting.
Attach the receiver to the hot shoe on the
camera.
Connect Giga T Pro II to the remote
control socket of the Camera, using the
correct connector cable included.
To switch On/Off the Receiver, press and
hold the Power Button. Switch on the
camera.
To switch On/Off the Transmitter, press
and hold the Power Button. Note: The
transmitter automatically powers off after
60 seconds of inactivity.
LCD Backlight
On Receiver: Press and hold backlight
Button
3
Transmitter 4-Way Joypad
IRL/GB
Centre button to confirm and accept
10
settings
Arrow buttons. To select the Mode
11
Settings, eg. Single Shooting,
Continuous Shooting, Delay, Long,
Timer, use left and right directional
arrows
To adjust the values for the timer,
exposure count & intervals or
channels, use the up and down
directional arrows.
Interval Timer Functions
Delay Setting
13
Long Setting
14
Interval 1 Setting
15
N1 Number of Exposures
16
Interval 2 Setting
17
N2 Number of Repeats
18
Seconds
19
Minutes
20
Hours
21
Standard Wireless Remote
Control Functions
Channel Selector
22
Basic Timer Mode
23
Bulb Mode
24
Continuous Shooting Mode
25
Single Shot Mode
26
On Transmitter: Press and hold backlight
Button
Channel Selection
To communicate between the transmitter
and receiver, both units must be on the
same channel.
The default on both LCD screens displays
the active channel (sample: CH02). To
change channel on the receiver, press and
hold BOTH Channel selector buttons until
the LCD screen flashes. Use individual
channel buttons to change the channel
setting. To set and confirm the channel,
press BOTH channel selector buttons.
To change channel on the transmitter, use
the 4-way joypad to go to Channel
Selector mode and press the centre
button. Adjust using the 4-way joypad, set
and confirm using the centre button.
Refer to FAQ for benefits of additional
channels
9
9