Optional Accessories - IKAR DB-A1 Mode D'emploi

6. Adjustable rubber feet:
The rubber feet feature a fold-away
design for better adaption to ground
conditions.
The horizontal position (Illus. 9) is recom-
mended for hard and stable ground.
The vertical, tip-standing position is
recommended for softer ground (Illus. 11)
in order to prevent slipping

7. Optional accessories:

IKAR fall protection device HRA with
rescue lifting gear:
The IKAR fall protection device HRA with
rescue lifting gear is attached to the leg
bearing the type plate with the fixture.
Mount the fixture (Illus. 11, 12 and 13) to
the leg in a way that enables the safety
staff to ergonomically operate the rescue
lifting handle. The proper clamping force
of the fixture is obtained through the
length (45.8mm) of the included spacing
sleeves.
The fastening torque of the hexagon
screws M 10 x 75, quality 8.8 is 49Nm.
The locking bar must be positioned ac-
cording to the device size. The fastening
torque of the cylinder-head bolts M 8 x
40, quality 8.8 is 40Nm. Insert the IKAR
HRA device into the fixture. The IKAR
HRA device is secured with a locking pin.
Attention: Only mount IKAR fixtures.
Only IKAR devices may be mounted in
IKAR fixtures.
Deflection roller with snap-hook:
The deflection roller (Ill. 14) serves to
guide and deflect the steel rope of the
IKAR fall protection device HRA.
For this purpose, open the closed
deflection roller by reciprocal rotation of
the two metal sheets and insert the steel
rope into the guide into the cannelure.
Next, turn back the two metal sheets.
Hang the snap-hook onto the deflection
roller and engage at the attachment point
of the tripod
Note: The IKAR HRA device retracts the
rope automatically as long as the rescue
lifting function is not engaged.
ENGLISH
.
Illus. 9
Illus. 11
Illus. 14
14
Illus. 10
Illus. 12
Illus. 13
Spacing sleeve
Position HRA 9,5-12
Position HRA 15-18
Position HRA
24, 33, 42
Locking bar