Advanced Settings - Vicks VNT275CA Manuel D'instructions

1) When the thermometer is turned on or off, press the MEMO button to view the
history of measured values.
2) An empty memory cell shows "----°C" or "----°F".
3) Temperature readings can be stored in memory. Up to 50 temperature readings can
be stored into the memory cells and automatically overwrite historical data.
4) While the thermometer is on, press the MEMO button until the LCD display "CLR",
which means that all stored data is cleared completely.
Changing the Temperature Scale – F1
Turn the thermometer on, press and hold the SET button to enter F1, press the "MODE" or
"MEMO" button to switch Celsius and Fahrenheit temperature units, press the trigger to
confirm the unit settings (factory default is Celsius).
Turning the Sound On/Off
While the thermometer is turned on, press the SET button to turn on or off the prompt
sound function.

Advanced Settings:

Warning: The following settings are only meant to be used by professionals.
It is recommended to keep this thermometer at the settings originally
programed on the device.
Fever Alert Set – F2
This setting will change at what point the backlight colour of the temperature reading
turns to red. After entering the screen for changing the temperature scale, F1, press
the "SET" button to enter F2. Press the "MODE" button to decrease this value by 0.1°C
(~0.2°F). Press the "MEMO" button to increase this value by 0.1°C (~0.2°F). Press
the "SET" button to save the setting. The factory default and highly recommended
temperature to have this set at is 38.5°C (101.3°F).
Sound Settings – F3
This setting will change the buzzer to be on or off. While in Fever Alert Setting, F2, press
the "SET" button to enter F3. Press the "MODE" or the "MEMO" button to turn the volume
on or off. Press the "SET" button to save this setting. This can also be changed using the
directions outlined in "Turning the Sound On/Off".
9