monzana DBDL006 Manuel D'instructions page 21

warm to prevent reduced work performance.
CAUTION:
device, disconnect it from the compressed air
1. Disconnect the device from the compressed air
supply.
2. Remove all nails.
3.
•
•
knob clockwise.
4. Load the nails as described above.
5. Connect the device with the compressed air
hose.
Too deep
Too high
21 www.DeubaXX L . de
by turning the cover.
Nail indicator
be loaded again. Then the device is loaded with
a strip of nails, the indicator is not visible. If the
nails are used up, the indicator will light up.
The unit should be recharged when half the red
Flush
sure you are not pressing the trigger and the
device is disconnected from the compressed air
supply.
Flush
If you wish to protect the work surface from
to the retainer.
1. Disconnect the air hose from the device.
2.
Nail indicator