golmar Tekna Uno Manuel D'installation page 13

TELEPHONES PROGRAMMING
P
rogramming the T-540 Uno telephones.
Set to ON the SW2-2 configuration dip switch in the door panel, refer to
the instructions manual (T63 /PLUS ML "page 11 " or T500SE ML 2
"page 117") that's enclosed with the door panel.
The door panel will reproduce a tone to advise that the system has
entered into programming mode.
In systems with more than one door panel, the programming process
shall be done on the master door panel only.
To program the telephone from a general door panel (if exist), see the manual T63 /PLUS ML page 11
or T500SE ML page 120.
Lift the handset while pressing the lock release push button.
To show that the system is ready for programming, the door
panel and handset will reproduce a tone, being possible to
stablish audio communication.
Release the lock release push button.
M S
Each apartment must have one master unit only; in case of parallel units configure them as slaves,
both monitors or telephones.
Make a call to check that the telephone has been succesfully programmed.
Repeat these steps to program the rest of telephones.
Once the programming has been finished, set to OFF the programming
switch. If you don't, the door panel will reproduce a tone to advise that the
system is still into programming mode.
4
2
Press the door panel push button that will call
to this telephone. At this moment the door
panel and handset will reproduce a tone.
With the handset lifted:
If programming the telephone as , replace
Master
the handset.
If programming it as , press the door release
Slave
push button, then replace the handset.
23 24
7
NOTAS/NOTES