fluidra 74139 Manuel D'instructions page 25

6.Operation
(1) Guide for operation
(2) Start the pool heat pump
Press to start the heat pump, the LED display will show the inlet water temperature and current working mode after 5s.
(3) Stop the pool heat pump
Press once again to stop the heat pump, the LED display shows 'OFF'
(4) Water temperature setting
Press or to set the desired water in temperature in current working mode, then Press
(5) TIME setting
Press button ,then press
** HOUR SETTING**
Press again to "HOUR" setting , "HH" flashed ,then press
**MINUTE SETTING**
Press to enter into MINUTE setting ,"MM" flashed , then press
(6) TIMER ON Setting
Press button ,then press
on controller ,Press
time.
(7) TIMER OFF Setting
Press button ,then press
displaying on controller ,Press
the stopping time .
**Above operations, you could press
to enter into " TIME " display ;
button twice to enter into TIMER ON setting .When you see the starting time displaying
to confirm to enter into TIMER ON setting interface , finally press
button 3 times to enter into " TIME OFF" setting . When you see the stopping time
to confirm to enter into TIMER OFF setting interface , finally press
button to save the setting and quick-exit the program. **
or to adjust the HOUR from 0 to 23 ;
or to adjust the MINUTE from 0 to 59.
21
to save setting and exit.
or to adjust the starting
or to adjust