Frequency Response - SE Electronics X1 S Mode D'emploi

Signal-to-noise ratio
Low cut filter
Attenuation pad
Powering
Electrical Impedance
Recommended load impedance
Current consumption
Connectivity
Dimensions
Weight

Frequency response

Support
In case you are experiencing any problems or have any questions regarding your sE product,
please contact your dealer first for the fastest and more direct service. If an authorized service is
required, it will be arranged by that dealer:
If you still have difficulties with support or assistance, please do not hesitate to contact us directly:
http://www.seelectronics.com/contact-us
Lastly, remember to register your new gear to extend your warranty to a full three years:
http://www.seelectronics.com/registration
Contact
Feel free to contact us:
sE Electronics International, Inc.
PO Box 1049
6 Beach Road
Tiburon
CA 94920 USA
Our international distributors & sales representatives:
This product conforms to the standards listed in the Declaration of Conformity. Please contact us
if you want to order a free copy of the Declaration of Conformity. Technical data subject to change
without notice.
85 dB
80 / 160Hz, 6 dB/Oct, switchable
10 / 20 dB, switchable
48 Volts according to IEC 61938
125 Ohms
>1k Ohms
6 mA
3-pin male XLR connector
Diameter: 58 mm (2.28 in.) Length 169 mm (6.65 in.)
440 g (15.52 oz.)
http://www.seelectronics.com/dealers
http://www.seelectronics.com/contact-us
Polar Pattern
www.seelectronics.com
contact@seelectronics.com
4