SE Electronics X1 S Mode D'emploi page 23

sE Electronics RF-X Assembly + Use
The ideal placement for your microphone is where the mic's capsule is approximately
even with the front edge of the RFX, and centered vertically with the filter – but some
mics sound better when pushed a little closer, and some a little further away.
Once you've found a good position for the mic and filter, you can loosen the lever on top
of the mic stand mount to move the filter and mic assembly forward or back – this way,
you can position it so its center of gravity is balanced directly above the mic stand.
Thank you for being an sE customer - enjoy your new RF-X!
F o r m o r e i n f o r m a t i o n , a n d t o r e g i s t e r f o r y o u r e x t r a y e a r
o f w a r r a n t y, p l e a s e v i s i t
RF-X ASSEMBLY MANUAL
STEP THREE
Your microphone, in a shockmount or a clip,
will attach to the hardware with the included
standoff.
You can now play with the horizontal
positioning of the mic, and the height of
the RFX, to get the optimum position for
recording.
s e e l e c t r o n i c s . c o m .