On And Off; Language Selection; Series Selection; Changing Batteries - Alcad PS PROGRAMMER PS-003 Manuel D'installation Et Programmation

PS PROGRAMMER
1.

ON AND OFF

If the programmer is new, insert the battery. The programmer will be
switched on by pressing any key. To switch it off, press the OFF key.
When the programmer switches on, it will display the version number for
2 seconds.
The programmer will automatically switch off 3 minutes after pressing the
last key. When switching it back on, it retrieves the last selected function.
2.

LANGUAGE SELECTION

Once the programmer is on, it will be waiting for the selection of the
series to be programmed; The display will show SERIES 912-TP or
another series id., then press the G key.
Press the F key followed by LANG. and select the language by means of
the J and K keys. Press G to confirm.
3.

SERIES SELECTION

Press the F key followed by SERIE+ to set the programmer to select the
series to be programmed; The display will show SERIES 912-TP or
another series id.. Press the J and K keys until selecting the desired
series and then press G to confirm.
4.

CHANGING BATTERIES

The PS programmer uses an alkaline 9V battery, type 6F22. When the
battery runs down, a message will be displayed:
EXHAUSTED
PS Programmer
and the programmer will switch off.
1
Fig. 1 - Changing batteries
2
ENG - 11
BATTERY