BaByliss PRO BigShot BAB821C Mode D'emploi page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

BLaDe care
Because the blades are precision-made for a very special use, they should always be
handled with care. Each time you finish using the appliance, take the cleaning brush
provided and brush away any loose hair and debris. Replace the blade guard onto the
blades. Then store the appliance to protect the blades until next use.
Be especially careful when changing or adjusting blades. When you have your clipper/
trimmer serviced, be sure that both blades are sharpened or replaced at the same time.
reMOVaL/repLaceMent OF BLaDe set
To remove blade set from your unit, unplug the unit from
electrical outlet, making sure the unit is in the 0-OFF position.
Remove the blade set by placing thumb against the smaller
cutter and pushing forward, releasing the cutter from the unit
housing. Replace with new cutting system and reverse the
removal procedure, only this time place your thumb on the
large cutter and snap it into place.
This unit (BAB821C) comes with two special blades, BAB500 for precision cutting and
BAB501 for trimming. Please altermate according to your need.
Do not pull, twist, or wrap line cord around the appliance. Continuous stress on supply
cord can damage cord insulation and result in a shock hazard.
Very iMpOrtant: the blade must be cleaned and oiled
before, during and after each use with the provided cleaning
brush and lubricating oil for proper functioning.
stOrage
When not in use, your clipper/trimmer is easy to store. Allow this appliance to cool, then
store out of reach of children in a safe, dry location. Do not jerk or strain supply cord
at plug connections.
BAB821C IB-11_630A.indd 7-8
Warning:
iF yOu tHinK tHe pOWer is OFF
WHen tHe sWitcH is OFF,
yOu're WrOng.
KEEP AWAY FROM WATER
Everyone knows that electricity and water are a dangerous
combination. But did you know that an electrical appliance
is still electrically live even if the switch is off? If the plug
is in, the power is on. So when you are not using the
appliances, keep them unplugged.
aLWays unpLug sMaLL
appLiances WHen nOt using.
1/28/15 2:25 PM

Publicité

Table des Matières
loading

Table des Matières