Guarantee - Dometic GROUP Waeco PerfectControl MPC 01 Instructions De Montage Et De Service

Guarantee

Programming the switchable outputs
You can define the switch points for switchable outputs 1 - 3 on the adapter board
(fig. 5 1, 2, 5, page 5). The set value (10% - 90%) is the total capacity of all batteries
connected. If the value for the current total capacity is greater than the set value, then
the output is switched to earth. If the value for the current total capacity is less than the
set value, then the output is not connected to earth.
➤ Navigate to the "Switchable output settings" menu page, see chapter "Navigating with-
in the menu" on page 29.
➤ Press the selector button to access setting mode.
➤ Turn the selector button to mark the value to change.
➤ Set the required value, see chapter "Changing values" on page 35.
Reading charger information and changing settings
➤ Navigate to the "Charger" menu page (page 30, see chapter "Navigating within the
menu" on page 29.
➤ Press the selector button to access setting mode.
➤ Turn the selector button to mark the value to change.
➤ Set the required value, see chapter "Changing values" on page 35.
Reading inverter information
➤ Navigate to the "Inverter" menu page (page 30), see chapter "Navigating within the me-
nu" on page 29.
Viewing battery history
I
NOTE
If the battery is discharged to less than 5% and then charged to more than 95%
capacity, only one entry is shown.
The menu page shows the date and time of battery charging and discharging processes.
Up to 50 entries are saved.
➤ Navigate to the "Battery history" menu page (page 32), see chapter "Navigating within
the menu" on page 29.
9 Guarantee
The statutory warranty period applies. If the product is defective, please contact the man-
ufacturer's branch in your country (see the back of the instruction manual for the address-
es) or your retailer.
For repair and guarantee processing, please send the following items:
 Defect components
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
36
PerfectControl MPC01
EN