Dometic GROUP Waeco PerfectControl MPC 01 Instructions De Montage Et De Service page 35

PerfectControl MPC01
Changing values
➤ Press the selector button so the value can be changed.
➤ Turn the selector button to set the required value.
➤ Press the selector button to save the value.
When values are being changed, an arrow appears (fig. 7 1, page 6).
➤ Turn the selector button to mark the arrow.
➤ Press the selector button to exit setting mode.
➤ Turn the selector button until the message "Press to return" appears and then press
the selector button.
✓
This will return you to the "Main menu".
Changing system settings
➤ Navigate to the "System settings" menu page (page 30), see chapter "Navigating with-
in the menu" on page 29. Set the values for:
– Date and time
– Alarm
➤ Press the selector button.
➤ Turn the selector button to access the relevant parameter.
➤ Press the selector button and turn it to set the required value.
➤ Confirm the value by pressing the selector button.
Setting time intervals
➤ Navigate to the "Stand-by settings" menu page (page 30), see chapter "Navigating
within the menu" on page 29.
Set the interval after which the main menu should appear automatically (fig. 8 1, page 6)
or after which the MPC 01 should switch to stand-by mode (fig. 8 2, page 4). You can
choose between the following intervals: 30 sec, 1 min, 2 min, 10 min.
➤ Set the required value, see chapter "Changing values" on page 35.
Reading battery values
➤ Navigate to the menu page for the battery required, see chapter "Navigating within the
menu" on page 29.
I
NOTE
The "Overview of supply batteries" menu page displays an average value for
all supply batteries.
Changing the settings for batteries A, B and C
➤ Navigate to the "Battery details" menu (page 32), see chapter "Navigating within the
menu" on page 29.
➤ Navigate to the menu page for the battery required.
➤ Press the selector button to access setting mode.
➤ Turn the selector button to mark the value to change.
➤ Set the required value, see chapter "Changing values" on page 35.
EN
Operating the MPC01
35