Glass Panel Installation - OVE KELSEY Mode D'emploi

1. Insert the fixed panel's bottom seal strip (N) and the side panel's bottom seal strip (L) at the base of the fixed panel
(C) and side panel (K).
2. Insert the fixed panel (C) and the side panel (K) into the wall tracks (B). Do not fully tighten it as further adjustments
may be required.
Note: The wall track (B) allows you to adjust the position of the fixed panel (C) and side panel (K). Adjusting
the depth and/or giving the side panel a slight angle allows for precise alignment with the door.
3-4 Smoothly slide the guide (Q) at the bottom of the fixed panel (C) and the side panel's clamp (V) at the bottom of
the side panel (K) both without securing. Mark the positions of holes of the guide (Q) and the clamp (V).
5. Drill pilot holes with a ø1/8" (3mm) drill bit.
6-7. Fix the guide (Q) and the clamp (V) with the screws (II) and caps (GG).
1
C
&
N L
3
C
Q
5

GLASS PANEL INSTALLATION

&
K
ø1/8"
3mm
6
Helpful Hint
Add a drop of
silicone in the
holes before
GG
inserting the
screws
II
10
2
B
&
C K
4
K
V
7
GG
II