Reflecta DigiMicroscope Flex Mode D'emploi page 48

FCC compliance statement (United States only)
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.
Changes or modi cations not expressly approved by the party responsible for compliance could void the user's authority to operate
this device.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This device generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
device does cause harmful interference to radio or television reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the device into an outlet on a circuit di erent from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Legal information
This document is published without any warranty. While the information provided is believed to be accurate, it may include errors
or inaccuracies. In no event shall the manufacturer or its distributors be liable for incidental or consequential damages of any nature,
including but not limited to loss of pro ts or commercial loss, arising out of the use of the information in this document.
All rights reserved. Mac, Mac OS and OS X are trademarks of Apple Inc., registered in the U.S. and other countries. Windows is a
registered trademark of Microsoft Corporation in the United States and other countries. All other trademarks and brands are property
of their respective owners.
BP05271