Publicité
Les langues disponibles
Les langues disponibles
Rear Panel Features
1.
AC MAINS - After all other connections have been made and confirmed, using the
included power cord, connect the AC Mains on the IS-AMP340 to an unswitched AC
outlet.
2.
STATUS LED - Shows the status of the IS-AMP340 unit:
Green - shows the unit is ON
Red - shows the unit is OFF
Blinking - shows communication, BT pairing, system start or firmware update
3.
IR OUT - Used for connecting IR emmiter (optional).
4.
ANALOG IN - Using a quality stereo RCA to RCA cable, connect the L&R output on
a stereo audio source to ANALOG IN L&R inputs on the IS-AMP340. This input can be
selected pressing RCA on IR remote or from the app. This input can also be selected
from the IS-AMP340 unit WEB page via Ethernet connection.
5.
SUB OUT - Using a quality RCA to RCA cable, connect the SUB OUT on the IS-AMP340 to
the SUB IN on a powered subwoofer or sub amp. Once the initial sub settings have been
made, the Volume Control will adjust both Speaker and Sub Out levels as a master
control.
6.
SPEAKER OUT - Using 16AWG (max) speaker wire, connect the Right, Left and Center
speakers outputs on the IS-AMP340 to the appropriate speaker terminals on right, left
and center speakers. Before connecting the speaker wires, twist the ends of the speaker
wire so there are no strays that can cause shorts. See section: Connections/Speaker
Connections for additional information.
ELAC IS-AMP340 | www.elac.com | Page 6
3
1
2
9
8
10
Figure 1 IS-AMP340 Rear Panel Features
4
5
7
6
Publicité
Chapitres
