Publicité
Les langues disponibles
Les langues disponibles
Connections
Right Speaker
Red Wire
To Positive
Speaker Connections
1. Use 16AWG (max) 2-conductor stranded speaker wire for speaker connections.
2. Strip approximately 1/4 to 1/2 of an inch off the ends and twist the strands together so
there are no loose ends that can cause shorts.
3. On the amplifier rear panel, insert one end of each striped speaker wires into the provided
plug and tighten the screws. Ensure that all speaker wires are firmly attached to the plug.
4. Confirm polarity. (Red wire to +).
5. Repeat for left, right and center speakers, + and -.
6. Confirm connection and polarity for each channel: left, right and center.
7. Connect the speaker wires to the appropriate + and - terminals on the speakers.
8. Confirm connection, polarity and position.
ELAC IS-AMP340 | www.elac.com | Page 10
IS-AMP340 Rear Panel
SPEAKER OUTPUTS
R+
R- C+ C- L+ L-
(Optional)
Center Speaker
Figure 4 IS-AMP340 Speaker Connections
Red Wire
To Positive
Left Speaker
Red Wire
To Positive
Publicité
Chapitres
