Fuel Selector Switch; Break-In Period; Before Starting The Generator; Starting The Engine: Gasoline - Westinghouse WGen3600DFv Manuel De L'utilisateur

High Altitude Carburetor Kit Part# 518957
High Altitude DF Regulator: Part# 518043-1
Note: You must purchase both the Dual Fuel Regulator
and Carburetor Kit for proper high altitude operation.

FUEL SELECTOR SWITCH

Position the fuel selector switch on the front control panel
to the desired fuel choice.
Turn the fuel selector switch fully upward for gasoline
operation.
Turn the fuel selector switch fully downward for propane
operation.

BREAK-IN PERIOD

For proper break-in, do not exceed 50% of the rated
running watts (1800 watts) during the first five hours of
operation.
Vary the load occasionally to allow stator windings to heat
and cool and help seat the piston rings.
OPERATION

BEFORE STARTING THE GENERATOR

Verify that:
• The generator is placed in a safe, appropriate location.
• The generator is on a dry, flat, and level surface.
• The engine is filled with oil.
• All loads are disconnected.
Fire and explosion hazard. DO NOT move or tip the
generator during operation.

STARTING THE ENGINE: GASOLINE

1. Verify that fuel is in the gas tank.
2. Turn the fuel selector switch on the control panel to
gasoline operation.
3. Turn the fuel tank valve to the ON position.
Note: If cold starting, move the choke lever to the ON
position.
4. Push the Run/Stop switch to the Run position.
5. Firmly grasp and pull the recoil handle slowly until you
feel increased resistance, then pull rapidly.
6. After starting, allow the engine to run for several seconds
then move the Choke lever to the fully OFF position.
Westinghouse Outdoor Power Equipment, LLC | 15