Simunition FX 9003 Guide D'utilisation page 15

Fig. 30
Mustache Foam Installation
F ig. 32
© 2019 GD-OTS Canada
Center of the
Goggle frame
Mustache Velcro
Hook edge
Fig. 33
Registered trademarks of General Dynamics Ordnance and Tactical Systems-Canada Inc. are denoted by
Fig. 31
Bend the Mustache foam with your fingers and join both
together (see Fig. 32).
Then, align the thicker edge of the Mustache foam with the
center of the Goggle
thicker edge of the Mustache foam is also aligned with the edge
of the Mustache Velcro
Then, press firmly the Mustache Foam against the Mustache
®
Velcro Hook with your fingers. For maximum comfort, maintain
the thicker edge of the Mustache Foam in place to properly align
it with the Mustache Velcro
®
www.simunition.com
Forehead Velcro
Hook edge
frame (see Fig. 32). Make sure that the
®
Hook (see Fig. 33).
®
Hook edge (see Fig. 33).
.
®
®
ends
Page 15 of 36
8971965.FTSIM_rev12