Table des Matières
Publicité
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book carefully.
ASSEMBLY
1. Plug the spray gun into the compressor. Make sure the spray gun is fully inserted. (See
Fig. A1) After that, turn clockwise to adjust the spray gun to your desired position (See
Fig. A2) To disassemble, draw the spray gun out from the compressor.
2. Open the feeding cup cover and fill with paint. Then cover. (See Fig. B)
WARNING: Use paint specifically formulated for use with Air Brushes. DO
NOT use solvents that contain or emit harmful substances. DO NOT use
paints of high concentration, or the nozzle may be clogged.
3. Connect the air brush and the hub. (See Fig. C)
WARNING: Before operation, make sure the speed control button on the
hub is at the"Min" position. (See Fig. D)
OPERATION
1. Confirm the speed control button is set to "Min". Grasp the tool by the grip. Press
the on/off switch on the hub. The dual function trigger regulates both paint volume and
air flow. Depress the trigger to start the air flow. Pull the trigger back to regulate paint
volume. Set maximum paint volume using the tail adjust screw. (See Fig. E)
NOTE: The speed is fixed, and can not be adjusted by the speed control button on the
hub.
2. Press the on/off switch on the hub to turn off after use.
WORKING HINTS
Before use, check the compressor and the spray gun to ensure they can work properly.
Please clean the feeding cup and spray gun instantly after use.
The nozzle may be clogged after long-term use. Please use the brush to clean.
Please carry out repairs or renovations under the guidance of after-sales staff.
MAINTENANCE
Remove the battery before carrying out any adjustment, servicing or mainte-
nance.
There are no user serviceable parts in your power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean with a dry cloth. Always store your power
tool in a dry place. Keep the motor ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the ventilation slots. This is normal
and will not damage your power tool. Store the accessories in a dry place.
EN
9
Publicité
Table des Matières
