Philips Sonicare DiamondClean Smart HX9945/08 Mode D'emploi page 25

2
35_021_2499_1_Booklet_Lux_A6_US_v1.indd 25
3 Hold the top of the handle with one hand and
strike the handle housing 0.5 inch above the
1
bottom end. Strike firmly with a hammer on all 4
sides to eject the end cap.
Note: You may have to hit on the end several
times to break the internal snap connections.
4 Remove the end cap from the toothbrush
handle. If the end cap does not release easily
from the housing, repeat step 3 until the end
cap is released.
5 Holding the handle upside down, press the
shaft down on a hard surface. If the internal
components do not easily release from
the housing, repeat step 3 until the internal
components are released.
6 Remove the rubber battery cover.
7 Wedge the screwdriver between the battery
and the black frame at the bottom of the
internal components. Then pry the screwdriver
away from the battery to break the bottom of
the black frame.
25
English
13/02/17 16:38