Auxiliary Handle - KRESS 360 BPS BiPower Mode D'emploi D'origine

39694_BA_360BPS.book Seite 21 Mittwoch, 18. April 2012 9:45 09
Operation
Start up, battery operation
Charging the battery
Fit the additional handle
Insert battery
-WARNING-
Use only original KRESS batteries with the volt-
age given on the type plate of your machine.
Use of any other battery packs may create risk of
injury and fire.

Auxiliary handle

Operate the machine only with the ad-
ditional handle
Loss of control can cause personal in-
jury.
Place the additional handle in the working posi-
tion to provide a safe and fatigue-free working sit-
uation.
Tighten the lower hand grip of the additional han-
dle by turning in clockwise direction. Turn the
hand grip in anticlockwise direction to release it.
Depth setting
The required drilling depth X can be set by using
the depth stop .
Release the additional handle
depth stop into the additional handle.
Extend the depth stop until the distance between
the tip of the drill and the tip of the depth stop cor-
responds to the required drilling depth X.
Mains cable
If the mains cable is damaged while
working, pull the mains plug immedi-
ately.
Mains cable module
Mains cable module with Patent
Quick Interlock.
Connect the mains cable module to the handle.
The plug must snap in.
Use the mains cable module only for Kress power
tools. Do not attempt to operate other machines
with the module.
Damaged mains cable modules must not be used.
They must be replaced by a new Kress mains ca-
ble module immediately.
Push the two unlocking buttons and remove the
mains cable module from the handle.
Use only an original Kress mains cable module
and at least a heavy rubber tube cable (H07 RN-
F).
Sliding clutch
Always assume a safe standing position and hold
the power tool securely in both hands.
When the drill becomes wedged unexpectedly,
the power tool jerks.
Battery
and insert the
The battery is supplied partially charged.
Completely charge the battery before using
your power tool for the first time.
Battery with lithium-ion technology
Total discharge protection
The "Electronic discharge protection func-
tion" protects the LI battery against total dis-
charge. Should the battery discharge, the
power tool is switched off by a protective cir-
cuit. The power tool stops operating.
-WARNING-
Do not continue to press the On/Off switch
after an automatic shutdown of the power
tool.
The battery could be damaged.
If the tool insert becomes caught or is
jammed, the drive to the drill spindle
is interrupted.
Remove the load from the machine
immediately by retracting the drill.
Switch off the power tool and loosen
the drilling tool if the power tool is
blocked.
When switching on the machine with
a jammed drilling tool, high reaction
moments can occur.
-NOTE-
English 21
EN
360BPS-EN / 1205