Signal Led - BST HELIOS2.1 Manuel D'utilisation

DESCRIPTION
2.1 PA set composed of 1x 18" bass reflex subwoofer of 500W, two satellite arrays of 2 x 200W, 2 stands
and a full set of Speakon leads to connect the satellites to the subwoofer.
• 18" bass reflex Subwoofer of 500W
• 8 x 2-way satellites fitted with 2x 4" mid-ranges and a 1" dome tweeter
• 2.1 amplification module of 1x 500W (subwoofer) and 2x 200W (satellites)
• Built-in limiter
• Separate volume controls for subwoofer and satellites
• Adjustable cut-off frequency of the subwoofer
• Input sources: LINE/USB/FM/BT
• Line inputs via RCA & Combo JACK/XLR
• Line outputs via RCA & XLR
• Supplied with 2x 8m and 6x 50cm Speakon leads
• 2 stands + array bar
• Sturdy wooden cabinet with black acrylic lacquer finish
1. MP3 player display
2. USB input
3. PLAY/PAUSE button
4. MODE button: Press to select an input source among Bluetooth, FM,
AUX & USB
5. REPEAT button: Repeat the track
6. Back to previous track.
Long press: Vol-
7. Next track.
Long press: Vol+
8. EQ Select among various music styles
9. PROTECT LED: Lights up when the protection circuit is triggered.
10. POWER LED: Lights up when the unit is switched on.
11. PEAK LED: Lights up when the signal level is too high. Reduce the
volume level if this indicator lights up.
12. SIGNAL LED: Lights up when the unit receives an input signal
13. PHASE REVERSE
Use this switch to reverse the phase of the subwoofer.
14. SUBWOOFER Crossover Frequency
15. SUB VOLUME
Use this button to adjust the signal level of the Subwoofer.
16. CHANNEL L & R volume control
Use this button to adjust the signal level of the left & right satellites.
17. L & R CHANNEL Signal input via XLR/Jack combo connectors
18. L & R CHANNEL Signal input via RCA sockets
19. L & R CHANNEL Signal output via RCA sockets
20. L & R SIGNAL LINK OUTPUT via XLR
21. L & R SIGNAL OUTPUT: Connect to left & right satellite speakers.
22. Input voltage Selector Switch: The user can set an input voltage of 115V or 230V. The unit is set at factory to
230Vac which is the European standard. For use in the USA, set the switch to 115V. If you want to change the
© Copyright LOTRONIC 2018 Page 3