Fakir Prestige VISION Mode D'emploi page 11

VISION 8604.QXD 25.04.2006 16:07
Informations for your safety and notes on disposal
Safety Precautions
• Do not pull out the plug from power supply socket by pulling on the connecting lead.
• Do not pull the connecting lead over sharp edges or allow it to become jammed.
• Do not use damaged extension leads.
• lf required, the conpecting lead has to be replaced together with the cable rewind by a
specialist.
• Before any maintenance operation or replacing a filter, and after use, switch off the
appliance and pull out the mains plug.
• Keep the nozzles and ends of tubes well away from the eyes and ears.
• The appliance must only be used for dry vacuum cleaning. lt is not a dual-purpose
(wet/dry) vacuum cleaner.
• Do not use the appliance to pick up hot or glowing substances.
• Do not use the appliance to pick up coarse slivers of glass.
• Do not use the appliance to pick up any solvents, explosive liquids or gases.
• When using the turbo suction brush, keep the hands clear of the rotating brush roller
and take care not to run over the connecting lead.
• Do not store the appliarice in the open air.
• Do not exposure the machine to weather, humidity nor excessive heat.
• Clean the appliance only with a dry or slightly moist cloth. Do not allow any of the elec-
trical components (switches, plug, socket, electronics, etc.) to come into contact with
water.
Disposal instructions
• Please dispose of packaging materials, used or dirty filters and, eventu-
ally, the appliance itself in accordance with any official regulations or
guidelines which may apply.
• f facilities are available in your locality for the recycling of packaging
materials, please make use of these accordingly.
• When finally disposing of the appliance itself, please render it unserviceable before
taking it to the autorized place of disposal.
Seite 11
11