Setting The Clock - DNT IPdio Tune Mode D'emploi

Using the product
Auto scan
To search for a FM station, you need to press and hold 2 seconds the Next >>I or Previous I<< keys, this
will start scanning UP or DOWN the frequency band. Once a station has been found, the scanning will stop
automatically. If no station is found, then the tuning will stop once it is cycled through the entire FM band
(87.5-108MHz);
Changing the volume
You can change the volume by turning the dial clockwise to increase the volume and anticlockwise to
decrease the volume. The display shows the volume bar. You cannot change the volume when you are in
a menu or when the radio is connecting to a station.
Storing a radio station in a preset by the panel control
When a radio station is playing, just hold one of the preset buttons to store the station.
E.g. To store preset 1: press and hold the preset 1, then the LCD will show "Assigned to Preset 1"
Playing a preset radio station when a radio station is playing, briefly press the corresponding preset key,
e.g. if you saved Radio A to Preset 1, then just press the number 1 preset key. If you press a preset that
hasn't been allocated a station, then it will display "Preset # empty".
There is only 1 preset for the FM on the unit as the preset 2 and 3 is used for the Auto scan
function.
Storing a radio station in a preset by the front remote control
To store a preset, you must first be listening to the station that you would like to save, then press STORE
button. Then press the preset number you would like to save and allow 2 seconds to store the station into
the preset. The LCD will then show <Assigned to preset #>.
Once you have saved a station to one of the presets, you can recall it by pressing RECALL button.
Then press the preset number you would like to recall and the radio will connect to your station that you
recalled.

Setting the CLOCK

You don't need to setup the clock, because it is automatically updated by internet for GMT+1,
which is used most countries in Europe.
If you make a mistake at any point, press BACK button to go back to the previous screen.
Rotate the dial until the display says<Configure>.
Press the SELECT button.
Rotate the dial until the display says<time/date>.
Press the SELECT button.
Rotate the dial until the display shows the correct hour.
Press the SELECT button.
Rotate the dial until the display shows the correct minutes.
Press the SELECT button
- 36 -