DNT IPdio Tune Mode D'emploi page 34

Getting started
There is 1 LED near the RJ45 socket of Wired Ethernet , The green color indicate the net-
work link, the orange one indicate the network act.
If you select Wireless Only, It will be only used for Wireless Wi-Fi connec-
tion.
When the ESSID for the access point you want to connect to be displayed
on the screen, press the SELECT button. You might need to enter the
correct WEP(Wired Equivalent Privacy) or WPA(Wi-Fi Protected Access)
code.
If your network is not configured to need a WEP or a WPA code, the display
will show:
If the screen displays:
Then the network is using one of the encryption systems:
Wired Equivalent Privacy (WEP) or Wi-Fi protected Access (WPA). You
therefore need to enter the correct WEP or WPA code into the radio for it to
communicate with you network.
After 3 seconds the display goes into the code entry mode or press
SELECT.
To enter the code, rotate the dial to select each character of the code in
turn, pressing the SELECT button after each character.
Make sure the character you want is shown in the centre of the display to
be able to select it.
WEP and WPA codes are case sensitive to upper and lower case charac-
ters so you must enter them exactly.
After the final character, rotate the dial to select END and press the SELECT
key.
The display shows "Connecting to network" as the radio connects to the
network.
Then it will be displayed:
You my see a message saying <Station Update From Reciva>. This indi-
cates that some new radio stations may be available since you last con-
nected, or others may have ceased to broadcast. The list of available
stations will change.
- 34 -