Cautions On Wiring - Clarion NX409 Mode D'emploi

6. Cautions on Wiring

1. Be sure to turn the power off before wiring.
. Be particularly careful where you route the wires.
Keep them well away from the engine, and
exhaust pipe, etc. Heat may damage the wires.
. If the fuse should blow, check to see if the
wiring is correct.
If a fuse is blown, replace it with a new one of
the same amperage rating as the original (15A FUSE).
4. To replace the fuse, remove the old fuse on the back
of the unit and insert the new one. (Figure 8)
NOTE:
There are various types of fuse holder. Do not let the battery
side touch other metal parts.
caution
After the connection, fix the cord by a clamp
or insulation tape for protection.
Fuse holder
NX409/NZ409
CAUTION
Fuse (15A FUSE)
Figure 8
Figure 8
51