Installing The Main Unit - Clarion NX409 Mode D'emploi

5. Installing the Main Unit

This unit is designed for fixed installation in the
dashboard.
1. When installing the main unit in NISSAN
vehicles, use the parts attached to the unit
and follow the instructions in Figure 6.
When installing the main unit in TOYOTA
vehicles, use the parts attached to the vehicle
and follow the instructions in Figure 7.
Mounting Screw Holes (Side View of the Main Unit)
For NISSAN vehicle
Installing the Main Unit in NISSAN Vehicle
*1
Finisher ( )
Note:
*1: Position the face panel with its wide edge at the
bottom. Fit the edge into the groove of the main
NX409/NZ409
. Wire as shown in Section 7.
. Reassemble and secure the unit in the
Figure 5
Main Unit
Mounting bracket
(1 pair for the left and right sides)
Figure 6
dashboard and set the face panel and center
panel.
For TOYOTA vehicle
6- Spacer (thickness: 1mm)
6-Spacer (thickness: 1 mm)
6-Flat head screw
6- Flat head screws
(M5x8) (M5
(Attached to the main unit)
(attached to the main unit)
8)
49